нужна помощь. (проблема с кали)

Discussion in 'Болталка' started by lighter, 21 Sep 2016.

  1. Veil

    Veil Banned

    Joined:
    21 May 2015
    Messages:
    2,046
    Likes Received:
    3,420
    Reputations:
    72
    Мысль здравая. В Винде присваивается IP, но шлюза не вижу.
    [​IMG]
     
  2. Veil

    Veil Banned

    Joined:
    21 May 2015
    Messages:
    2,046
    Likes Received:
    3,420
    Reputations:
    72
    Так уже лучше - слаксварь запустил. Остался чертов Кали.
    Гребанная графика. Хуй забил на все и ручками, ручками через sudo pppoeconf все что надо получил.
    Не люблю больше GUI, терминал люблю.
     
    #42 Veil, 4 Mar 2018
    Last edited: 4 Mar 2018
    DartPhoenix and Evan like this.
  3. Veil

    Veil Banned

    Joined:
    21 May 2015
    Messages:
    2,046
    Likes Received:
    3,420
    Reputations:
    72
    Но не все так просто! Соединение рррое есть, только ручками, но дальше пока не продвинулся в Кали.
    oot@kali:~# ifconfig eth0
    eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
    ether 54:04:a6:a1:d2:25 txqueuelen 1000 (Ethernet)
    RX packets 241 bytes 19611 (19.1 KiB)
    RX errors 0 dropped 0 overruns 0 frame 0
    TX packets 503 bytes 64792 (63.2 KiB)
    TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0


    root@kali:~# route -n
    Kernel IP routing table
    Destination Gateway Genmask Flags Metric Ref Use Iface
    0.0.0.0 0.0.0.0 0.0.0.0 U 0 0 0 ppp0
    10.90.255.254 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0


    root@kali:~# ifconfig
    eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
    ether 54:04:a6:a1:d2:25 txqueuelen 1000 (Ethernet)
    RX packets 242 bytes 19671 (19.2 KiB)
    RX errors 0 dropped 0 overruns 0 frame 0
    TX packets 504 bytes 64822 (63.3 KiB)
    TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
    lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
    inet 127.0.0.1 netmask 255.0.0.0
    inet6 ::1 prefixlen 128 scopeid 0x10<host>
    loop txqueuelen 1000 (Local Loopback)
    RX packets 12372 bytes 1024644 (1000.6 KiB)
    RX errors 0 dropped 0 overruns 0 frame 0
    TX packets 12372 bytes 1024644 (1000.6 KiB)
    TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
    ppp0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST> mtu 1492
    inet 94.180.205.153 netmask 255.255.255.255 destination 10.90.255.254
    ppp txqueuelen 3 (Point-to-Point Protocol)
    RX packets 183 bytes 11896 (11.6 KiB)
    RX errors 0 dropped 0 overruns 0 frame 0
    TX packets 163 bytes 10012 (9.7 KiB)
    TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0


    root@kali:~# netstat -rn
    Kernel IP routing table
    Destination Gateway Genmask Flags MSS Window irtt Iface
    0.0.0.0 0.0.0.0 0.0.0.0 U 0 0 0 ppp0
    10.90.255.254 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0


    root@kali:~# ip link show
    1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DEFAULT group default qlen 1000
    link/ether 54:04:a6:a1:d2:25 brd ff:ff:ff:ff:ff:ff
    4: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1492 qdisc pfifo_fast state UNKNOWN mode DEFAULT group default qlen 3
    link/ppp


    root@kali:~# mii-tool eth0
    eth0: negotiated 100baseTx-FD, link ok


    root@kali:~# ethtool eth0
    Settings for eth0:
    Supported ports: [ TP MII ]
    Supported link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    1000baseT/Half 1000baseT/Full
    Supported pause frame use: No
    Supports auto-negotiation: Yes
    Advertised link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    1000baseT/Half 1000baseT/Full
    Advertised pause frame use: Symmetric Receive-only
    Advertised auto-negotiation: Yes
    Link partner advertised link modes: 10baseT/Half 10baseT/Full
    100baseT/Half 100baseT/Full
    Link partner advertised pause frame use: No
    Link partner advertised auto-negotiation: Yes
    Speed: 100Mb/s
    Duplex: Full
    Port: MII
    PHYAD: 0
    Transceiver: internal
    Auto-negotiation: on
    Supports Wake-on: pumbg
    Wake-on: g
    Current message level: 0x00000033 (51)
    drv probe ifdown ifup
    Link detected: yes


    root@kali:~# netstat -tupn
    Active Internet connections (w/o servers)
    Proto Recv-Q Send-Q Local Address Foreign Address State PID/Program name


    root@kali:~# netstat -tupln
    Active Internet connections (only servers)
    Proto Recv-Q Send-Q Local Address Foreign Address State PID/Program name


    root@kali:~# ip add
    1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
    valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
    valid_lft forever preferred_lft forever
    2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    link/ether 54:04:a6:a1:d2:25 brd ff:ff:ff:ff:ff:ff
    inet6 fe80::e730:b2a2:24ef:c9e3/64 scope link noprefixroute
    valid_lft forever preferred_lft forever
    4: ppp0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1492 qdisc pfifo_fast state UNKNOWN group default qlen 3
    link/ppp
    inet 94.180.205.153 peer 10.90.255.254/32 scope global ppp0
    valid_lft forever preferred_lft forever
    root@kali:~#
     
  4. Veil

    Veil Banned

    Joined:
    21 May 2015
    Messages:
    2,046
    Likes Received:
    3,420
    Reputations:
    72
    Где в этом кали графическое dsl / pppoe соединение найти ( раньше оно было)? В сетевых настройках что-то не нашел.((
    В слаксваре их туча, а в кали что-то ни хрена.
    После длительных мучений наконец запустил и Кали. Только из консоли, из графики не вышло. В графики показано , чтовообще ничего не включено.
    Теперь в конфиге кроме eth0 появился ppp0
    Вот сижу репу чешу, что ставить в некоторых программах. какой интерфейс?
     
    #44 Veil, 4 Mar 2018
    Last edited: 4 Mar 2018
Loading...